NEC LT20 - Manual (Page 15)

11 ... English
Installation
On/Standby
Powering On the Projector
1. Remove the lens cap.
2. Ensure that the power cord and signal cable are securely
connected. The Power LED will turn orange.
3. Turn on the lamp by pressing “On/Standby” button on the
control panel. n And the Power LED will flash green.
The startup screen will display for 20 seconds and the
Power LED will turn green.
4. Turn on your source (computer, notebook, video player,
etc.). The projector will detect your source automatically.
™ If the screen displays “No Input”, please make sure the signal
cables are securely connected.
™ If you connect multiple sources at the same time, use the
“Source” button on the remote control or control panel to select
your desired source.
Powering On/Off the Projector
™ Turn on the
projector first and then
the signal sources.
1