Nokia 5110 - Manual (Page 27)

Using the Menu
Copyright © 2004 Nokia. All rights reserved. 27
When on is selected, the phone will ask for the
security code whenever a new SIM card is insert-
ed.
Note: When you change the security , all
the recent calls lists are cleared.
Change Access Codes
With this menu (menu 4-3-5) you can change
the access codes; security code, PIN code and
PIN2 code. These codes may only include the
characters 0 to 9. The phone prompts you to en-
ter the current code and the new code. It also
prompts you to verify the new code.
Note: Avoid using access codes similar
to the emergency numbers to prevent
accidental dialling of the emergency
number.
Restore Factory Settings
You can reset some of the menu settings to their
original values (menu 4-4). The security code is
needed for this function.
Call Divert
(menu 5)
The Call Divert network service allows you to di-
vert the incoming calls to your voice mail (only
voice calls) or to another phone number.
The call divert modes available in
N5110 are
• Divert all voice calls without
ringing
• Divert when busy
• Divert when not answered
• Divert when the phone is off or
no coverage.
Then you can Activate, Cancel or check
Status of the selected mode. For some divert
modes also Set delay is available.
• With Cancel all diverts you can set
all diverts off.
Tip! If Divert when busy is activated,
rejecting an incoming call will also di-
vert the call.
Games (menu 6)
In this menu you have three
games,
Memory , Snake and Logic . Select the
desired game and then select Instructions
to see how to play the game.
REMEMBER! Your phone must be switched on to
use this function. Do not switch the phone on
when wireless phone use is prohibited or when it
may cause interference or danger.
Calculator
(menu 7)
The phone is provided with a basic four function
calculator which can also be used for rough cur-
rency conversions.
Using the calculator
Enter the first numbers in the calculation using
the
- keys. Press for a period(.).
Press once (+) to add, twice ( - ) to subtract,
three times ( * ) to multiply and four times ( / ) to
divide, or press (
Options ) to reach the desired
function.
For a total, press ( Options ) and select
Equal with ( OK ). Press to clear the
display.