Configuration guide, Selecting a management type, Contivity secure ip services gateway – Nortel Networks CG030601 User Manual
Page 7
Configuration Guide
Contivity Secure IP Services Gateway
Frame Relay on Contivity Secure IP Services Gateway
CG030601
2.00 July 2003
Page: 7 of 14
Figure 3 Configure WAN Interface
4. Enter the description and circuit number. The circuit number is only relevant for
administration purposes only. (Not used by system for identification of circuit.)
5. For the Interface Filter field, select the appropriate interface filter from the drop-down
list.
6. For the Protocol field, select Frame Relay Service from the drop-down list.
7. For the Data Rate field, select the appropriate line rate from the drop-down list.
Selecting a management type
You can specify the management protocol that the router and the frame relay network use
to communicate status information. Routers connected back to back also use a
management protocol to exchange status information. The following list describes your
options:
•
DLCMI None provides no management interface between the router and the
frame relay network. In the absence of management support, you must configure
all PVCs manually.
•
Rev 1 LMI provides user-side management services as specified by Revision 1 of
the LMI standard.