Nortel Networks Nortel M 7000 - Manual (Page 6)

Page 6
To send Hookswitch or DTMF during a conference call
Either system telephone engaged in a three-way conference call over a
Network CLID or DS trunk can issue a hookswitch or DTMF dialing request
without leaving the conference, if the feature is enabled.
Note: This feature is not available for i20xx telephones or Symbol
NetVision handsets.
– To hear DTMF tones on both telephones during dial, activate Long
Tones ( FEATURE 808).
– To conference in someone through the trunk, use Link ( FEATURE 71)
Contrast
adjustment FEATURE *7 plus a number from 1 to 9 to adjust the display contrast.
Press HOLD to set your choice.
Dialing modes FEATURE *82
Choose one of three methods of dialing.
1. Press
FEATURE *82.
2. Press # to select the mode.
3. Press
HOLD to store the mode.
Standard Dial: Select a line, then dial the number. (Standard Dial is
always available, even when another dialing mode is selected.)
Automatic Dial: Dial the number without choosing a line button first. Your
prime line is automatically selected for the call.
Pre-Dial: Dial the number, then press a line button to place the call. Edit
the number by pressing the volume bar before placing the call.
Do Not Disturb FEATURE 85 Cancel: FEATURE #85
When you are not on a call prevent all incoming calls, except priority calls,
from ringing at your telephone. When you are on a call, block an incoming
priority call.
Group
Listening
FEATURE 802 Cancel: FEATURE #802
Use both the handset and speaker while you are on a call. To avoid elec-
tronic feedback, keep the handset away from the speaker during the call,
and press
RLS to hang up. Note: Most of the portable handsets do not
have speakers, so cannot use this feature.
Telephone features