National Instruments NI PXIe-8360 User Manual
Page 13

Chapter 2
Hardware Installation
NI ExpressCard MXI Series User Manual
2-2
ni.com
4.
Make sure the injector/ejector handle is in its downward position.
Be sure to remove all connector packaging and protective caps from
retaining screws on the module. Align the NI PXI-8360 or
NI PXIe-8360 with the card guides on the top and bottom of the system
controller slot.
Caution
Do not raise the injector/ejector handle as you insert the NI PXI-8360 or
NI PXIe-8360. It will not insert properly unless the handle is in its downward position so
that it does not interfere with the injector/ejector rail on the chassis, as shown in Figure 2-2.
5.
Hold the handle as you slowly slide the module into the chassis until
the handle catches on the injector/ejector rail.
6.
Raise the injector/ejector handle until the module firmly seats into the
backplane receptacle connectors. The front panel of the NI PXI-8360
or NI PXIe-8360 should be even with the front panel of the chassis.
7.
Tighten the bracket-retaining screws on the top and bottom of the front
panel to secure the NI PXI-8360 or NI PXIe-8360 to the chassis.
8.
Replace or close any doors or covers to the chassis.