Logging into and out of the network, Quick start hints, Active handset display – Nortel Networks NP-4046-100 User Manual
Page 3: Netvision quick start call basics
Page 3
A handset user guide is supplied with each Symbol
®
NetVision handset which describes, in detail,
how to use the buttons on the handset, including any data-related buttons found on the NetVision
Data phone. Note: The buttons described here are not located in the same place on all models.
You must be logged into the network:
The handset display shown below is from the NetVision handset. If you have a NetVision data
telephone or a new version of the handset, the shape of the display may have a different
appearance, however, the icons on all handsets indicate the same thing:
Logging in:
Logging out:
Press
to turn the handset on.
Press and hold
to turn the handset off.
Enter your PIN number, and press
.
Make call:
Enter number and press
.
Answer Call:
Press
.
If you pressed
to silence a ringing call, to
retrieve the call, press
or
choose
Off-hook, if it is programmed into
the menu.
Note: This sequence also produces a dial tone
on an idle telephone.
End call or feature:
Press
.
To Hold or Unhold a call, or to toggle
between two calls:
Press .
To Hold the call and drop the link so someone
else can pick it up, press
.
To recover a held call from a dropped link,
press: .
Logging into and out of the network
SND
SND
END
END
SND
SND
Quick start hints
SND
SND
SND
SND
END
END
<
SND
SND
FCT
END
END
HOLD
HOLD
HOLD
HOLD
END
END
<
SND
SND
HOLD
HOLD
Active handset display
NAME
XXX-XXXX
Radio signal strength indicator
Active line indicator
Battery strength
indicator
Call information
Idle/alert icon
active call icon
NetVision quick start call basics