Nortel Networks Passport 241-5101-200 - Manual (Page 37)

37
Passport 8250 Installation Guide R2.2
Chapter 4
Configuring the Passport 8250 for operations
This section provides the following procedures for configuring the Passport
8250 device for the operations:
1 “Logging into the CLI” (page 37)
2 “Configuring the Passport 8250 device for remote access” (page 38)
3 “Configuring the clocking scheme” (page 40).
Logging into the CLI
The first time you log into the CLI, you need to do the following:
• Access the CLI using a terminal emulation device that is directly
connected to the Passport 8250 device. The terminal emulation device
must have a standard terminal emulation software.
• Create a password. The password is used for CLI sessions, Telnet
sessions, and FTP sessions.
Note: The userid for CLI sessions, Telnet sessions, and FTP sessions is
admin.
Starting the Passport 8250 device and logging into the CLI
1 Start a hyperterminal session on the local host.
2 Start the Passport 8250 device: