beautypg.com

Operation, Halogen bulbs – NuTone NP63000 User Manual

Page 9

background image

- 9 -

LIGHT

SWITCH

PILOT

LAMP

BLOWER

SPEED

CONTROL

BLOWER

ON / OFF

SWITCH

OPERATION

Controls

The hood is operated using the slide controls

under the front edge of the hood.
The light switch turns the halogen lights on

and off.
The blower on / off switch turns the blower on

to the running speed set by the blower speed

control. The blower must be turned on and off

using this switch.
The blower speed control changes the running speed of the blower (1-2-3).
The pilot lamp lights up whenever the blower is on.

HEAT SENTRY™

Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a

device that will turn on or speed up the blower if it senses excessive heat above

the cooking surface.

1) If blower is OFF - it turns blower ON to HIGH speed.

2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.

When the temperature level drops to normal, the blower will return to its original

setting.

WARNING

The HEAT SENTRY thermostat can start the blower even if the hood is turned

OFF. When this occurs, it is impossible to turn the blower OFF with its switch.

If you must stop the blower, do it from the main electrical panel.

HALOGEN BULBS

This range hood requires 4 halogen bulbs

(Type T3, 12Volt, 20Watt Max, G-4 Base).
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:

1. Loosen the ring nut by turning it

counterclockwise.

2. Pull the bulb downwards to remove - DO

NOT ROTATE. CAUTION: BULB MAY BE

HOT!

3. Replace with Type T3, 12Volt, 20Watt Max,

G-4 Base halogen bulb. Do not touch

replacement bulb with bare hands!

RING

NUT