Audi – Neo Car Audio Car Audio User Manual
Page 6
V E H I C L E I N S T A L L A T I O N
4
Audi
Make sure you have your radio’s theft protection code before you attempt installation.
When you reconnect power to the battery, you will need to enter this code.
Information about the theft protection code can be found in your vehicle’s audio
operation manual.
Before connecting any cables to the black box you must set the dip switch to the Audi
position. If you set the dip-switches after you have connected cables to the box, you
must disconnect and reconnect them for the iON to operate.
§ All Models (1998-2004) – Pre-wired 13-pin CD iON cable in the left-rear
trunk of all Audi vehicles.
§ Audi A8 (2003-2004) – Not Compatible.
§ Audi A6 (2004) – Not Compatible.
Once you connect the Neo iON, turn on your radio. A CD icon will appear on the
display of your radio showing that the Neo iON is ready to use. This step may
take up to three minutes and could require the iPod be connected.
Plug an iPod into the iON’s connector
Switch to the Neo iON by pressing the CD/Mode button on the radio.
Select a playlist and press play on the iPod
To change tracks simply press “Seek <” or “Seek >”
To FF/RW simply hold “Seek <” or “Seek >”
S E T T I N G S
F O R A L L
A U D I S
1
2
3
4
5
6
7
8
ON
OFF
OFF
OFF
OFF
OFF
OFF
ON
O P E R A T I O N