Neo Car Audio Car Audio - Manual (Page 3)

D E S I G N C U S T O M I Z A T I O N
1
Installation Preparation
This chapter provides information required for the installation
of the Neo iON, it must be read by all users.
Thank you for purchasing the Neo iON. Since the Neo iON works in many different
vehicles the following steps must be taken to ensure the iON is set up correctly for the
vehicle it is being installed in.
Before Installation
To prevent damage to your vehicle and the iON take the following precautions.
1. Turn off the ignition and remove the negative (-) battery cable prior to
installation.
NOTE: If the vehicle is equipped with an on-board drive or navigation computer, do
not disconnect the battery cable. If the battery cable is disconnected, the computer
memory may be lost. Under these conditions, use extra caution to avoid causing a
short circuit during installation. If your radio has a security code make sure you
know the code and how to enter it prior to removing the battery cable. The
radio will require this code to operate when the battery terminal is reconnected.
2. Do not install the unit in the following locations:
A. Locations exposed to direct sunlight
B. Locations where hot air flows from the cars heater
Chapter 1