Nokia 260S - Manual (Page 10)

GB 10
Installation
First-time installation
Once you have correctly connected the Mediamaster, you will also
have to perform a "First-time installation." During this procedure,
helpful information is displayed at the bottom of the menus.
The OK button always confirms a selection within the menus, and
pressing it will take you to the next step in the installation
procedure. However, more than one value often has to be entered
in a menu. First, make all necessary setting changes. Then, confirm
them all simultaneously by pressing OK.
• You can always return to the previous menu by pressing back.
• Use the cursor up/down button to move upwards and
downwards from one line to another.
• Use the cursor left/right button to change settings.
• You also use the number buttons on the remote control to enter
numeric values.
• Plug in your Mediamaster and the "First-time installation" menu
appears.
• Press OK to continue.
Language
• Select the desired menu language using the cursor up/down
button.
This will also become the main language for audio and
subtitling.
• Press OK to continue.
Antenna/satellite selection
• Select the "One antenna/one LNB configuration" alternative if
you have a single antenna equipped with one LNB for receiving
signals.
• Select the "Multisatellite/DiSEqC switch configuration"
alternative if you have one antenna with two or four LNBs or two
antennas with one or two LNBs each for receiving signals from a
combination of satellites. In this case, you will need a 2-way or a
4-way DiSEqC switch.
• Select the "Motor antenna configuration" alternative if you have
an antenna motor to control your satellite antenna.