N3g005w – NetComm 3G Wireless Router User N3G005W User Manual
Page 77
YML894 Rev3
N3G005W 3G Wireless Router User Guide
N3G005W 3G Wireless Router User Guide
www.netcomm.com.au
N3G005W
1.
Open your web browser (i.e. Internet
Explorer or Firefox) and navigate to
http://192.168.123.254/.
2.
At the login screen, type in admin in the
System Password field. Then click on Login.
3.
Click on Basic Setting and then click on Wireless.
4.
After that you will be presented with the
wireless setting page. On this page you can
configure the wireless security.
5.
To use WEP, please configure the following:
•
Change Security to WEP
•
Change WEP Encryption to 64bit or 128bit
(This example uses 64bit)
Notes:
64 bit needs 10 digits key and 128 bit needs 26 digits key.
•
Type in the key in Key 1 field (This
example uses “a1b2c3d4e5” key)
Notes:
WEP key can only use numbers (0 to 9) and letters (A to F).
•
Click on Save to save the settings
6.
To use WPA, please configure the following:
•
Change Security to WPA-PSK
•
Change Encryption Type to TKIP
•
Enter the WPA key in the Passphrase field.
Notes:
The key needs to be more then 8 characters and less then
63 characters and it can be any combination of letters and
numbers.
•
Click Save to save the settings
Notes:
Wireless client network cards must be WPA-compliant to
connect to a WPA enable network, if in doubt check the wireless
client network card documentation, or use WEP security.
Notes:
After changing the security settings, you might need to remove
the current wireless settings on the computer and reconfigure
the wireless computer according to the new settings.