beautypg.com

N3g005w – NetComm 3G Wireless Router User N3G005W User Manual

Page 55

background image

YML894 Rev3

N3G005W 3G Wireless Router User Guide

N3G005W 3G Wireless Router User Guide

www.netcomm.com.au

55

N3G005W

Advanced.Setting.>.Routing
When you have more than one router or subnet on your network, you need to enable routing function to allow

different subnets to communicate with each other.

There are two types of routing feature on the N3G005W Wireless Router, Dynamic routing and Static routing.
Dynamic Routing use RIP protocol to allow the N3G005W to adapt to changes in the network. RIP enables the

device to determine the best route for each packet based on the “hop count” or number of hops between Source

and Destination. Tick on Enable tick box to enable Dynamic Routing. Please select RIPv2 only if you have different

subnet in your network. Otherwise, please select RIPv1 if you need this protocol.
Static Routing allows computers that are connected to the N3G005W to communicate with computers on another

LAN segment which are connected to the N3G005W via another router. You can specify up to eight routing rules.

To set a rule, you need to specify the following:

IP address

Subnet mask

Gateway

Hop, number of hop.

And tick on Enable for each rule.

Click Save to save the settings and Undo to cancel.