National Instruments NI 783xR - Manual (Page 47)

Appendix A Specifications
NI 783xR User Manual A-2 ni.com
Maximum working voltage
(signal + common mode) ........................Inputs should remain
within
±12 V of ground
Overvoltage protection
...........................±42 V
Data transfers ..........................................Interrupts, programmed I/O
Accuracy Information
DC Transfer Characteristics
INL
..........................................................±3 LSB typ, ±6
LSB max
DNL ........................................................–1.0 to +2.0 LSB max
No missing codes resolution...................16 bits typ, 15 bits min
CMRR, DC to 60 Hz ..............................86 dB
Dynamic Characteristics
Bandwidth
Small signal (–3 dB)........................650 kHz
Large signal (1% THD) ...................55 kHz
System noise ...........................................1.8 LSB
rms
(including quantization)
Nominal Range (V)
Absolute Accuracy
Relative
Accuracy
% of Reading
Offset
( µV)
Noise +
Quantization
( µV)
Temp
Drift
(%/ °C)
Absolute
Accuracy
at Full
Scale
(
±
mV)
Resolution ( µV)
Positive
Full
Scale
Negative
Full
Scale
24
Hours 1 Year
Single
Point Averaged
Single
Point Averaged
10.0 –10.0 0.0496 0.0507 2542 1779 165 0.0005 7.78 2170 217
Note: Accuracies are valid for measurements following an internal calibration. Measurement accuracies are listed for
operational temperatures within
±
1 °C of internal calibration temperature and
±
10 °C of external or factory-calibration
temperature. Temp drift applies only if ambient is greater than
±
10 °C of previous external calibration.