Nautique Crossover 90490 - Manual (Page 159)

8-5
Care and Maintenance
Propeller
Removal
1. Remove the cotter pin from the propeller shaft and discard.
2. Wedge a piece of 1" x 4" wood between the propeller blade and
the starboard side of the strut and rudder.
3. Remove the nylon locknut and discard.
• A propeller can be very sharp. Be careful when you
handle it. Wear a pair of protective gloves when
handling any propeller.
• Remove your key from the ignition and remove the
emergency stop switch clip from the switch to prevent
accidental starting of the engine.
• DO NOT reuse the nylon locknut or the cotter pin.
• DO NOT use a damaged propeller. A damaged
propeller can damage your engine and boat.
CAUTION
216V Sec 8_2009.qxd:Naut Air Sec 8.qxd 1/23/09 9:16 AM Page 8-5