Important safety notices – Niles Audio DMS4 User Manual
Page 6
6
IMPORTANT SAFETY
NOTICES
The serial number for this equipment is located on the rear
panel. Please write this serial number down and keep it in a
secure place. This is for your security.
Use the correct power cord for your country:
Waste electrical products must not be disposed of with
household waste. This equipment should be taken to your
local recycling centre for safe treatment.
Les produits �lectriques usag�s ne doivent en aucun cas �tre
produits �lectriques usag�s ne doivent en aucun cas �tre
doivent en aucun cas �tre
en aucun cas �tre
jet�s avec les ordures m�nagères. Cet appareil doit �tre
apport� à la d�chetterie pour subir un traitement adapt�.
Elektrische Geräte dürfen nicht mit dem Hausmüll entsorgt
werden. Wenden Sie sich für eine umweltgerechte Entsorgung
dieser Geräte an Ihren örtlichen Entsorgungsbetrieb.
I dispositivi elettrici non devono essere gettati insieme ai rifiuti
domestici. Tali apparecchiature devono essere consegnate al
centro di riciclaggio locale per il corretto smaltimento.
Los dispositivos electrónicos no deben desecharse junto con
los residuos dom�sticos. Este tipo de aparatos debe llevarse
al centro de reciclaje más cercano para su adecuado
tratamiento.
Safety information varies depending on the geographic region
in which this unit is sold and operated. Please refer to the
relevant section below for your country of sale and operation.
CaNadIaN mOdEl
Note: This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil num�rique de la Classe B est conforme à la norme
NMB-003 du Canada.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES,
INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS
LA BORNE CORRESPON-DANTE DE LA PRISE ET POUSSER
JUSQU’AU FOND.
u.s. mOdEl
CAUTION: This product satisfies FCC regulations when
shielded cables and connectors are used to connect the unit to
other equipment. To prevent electromagnetic interference with
electric appliances such as radios and televisions, use shielded
cables and connectors for connections.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Subpart
J, Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and
receiver
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician
for help
Changes or modifications may cause this unit to fail to comply
with Part 15 of the FCC Rules and may void the user’s authority
to operate the equipment.
CauTION
Use of controls or adjustments or performance of
procedures other than those specified herein may result in
hazardous radiation exposure
The use of optical instruments with this product will increase
eye hazard
Information to User
Alteration or modifications carried out without appropriate
authorization may invalidate the user’s right to operate the
equipment.
EuROPEaN mOdEl
Note: This product has been designed and type-tested to
comply with the limits set out in EN55013, EN55020,
EN60950, EN55022: 1998 CLASS B4, EN55024:
1998, FCC RULES PART 15 SUBPART B CLASS B. AS/NZS
3548:1995 CLASS B
CauTION:
LASER SAFETY: This unit employs a LASER. Only a qualified
person should remove the cover or attempt to service the device,
due to possible eye injury.
“CAUTION-USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURE OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.”
•
•
•
•
•
•