NEC 5224 - Manual (Page 28)

22
7. Press * or the Program softkey .
8. Dial the destination number.
If you make an error while dialing, press * or the <— softkey to correct errors.
9. Press ( DOWN ) or the Save softkey.
To turn Call Forward on and off (once it has been programmed):
1. Press ( SUPERKEY ).
2. Press # or the No softkey until "Call Forwarding?" appears.
3. Press * or the Yes softkey .
4. Press # or the Next softkey until the type of Call Forward appears. .
5. Do one of the following:
• On a 5212 IP Phone, press * ( Change ) and then press # ( TurnOff/TurnOn )
• On a 5224 IP Phone, press the Review softkey. Press the Change softkey.
• To turn Call Forward on, press the TurnOn softkey, or, to turn Call Forward off,
press the TurnOff softkey.
Call Forward - Remote (I'm Here)
To forward calls from a remote station to your current location:
1. Press ( SUPERKEY ).
2. Press # or the No softkey until "Call Forwarding?" appears.
3. Press * or the Yes softkey.
4. Press # or the Next softkey until "I Am Here" appears.
5. Press * or the Yes softkey.
6. On a 5212 IP Phone only, if a number is already programmed, press * twice.
7. Dial the extension of the remote station.
If you make an error while dialing, use the # or the <— softkey to backspace and correct
the number.
8. Press ( DOWN ) or the Save softkey.