NEC 5224 User Manual
Page 27
21
To add a call on Hold to an existing conversation or conference:
1. Press the AddHeld softkey.
2. Press the flashing line key.
Swap
To call another party when you are in an established two–party call:
1. Press
( TRANS/CONF ).
2. Dial the number.
To alternate between the two parties:
• Press the Swap/Trade feature key or the Trade softkey.
Call Forward
Call Forward lets you redirect incoming calls to an alternate number.You can select one of the
following forwarding options:
• Always redirects all incoming calls regardless of the state of your telephone.
• B–Int redirects internal calls when your telephone is busy.
• B–Ext redirects external calls when your telephone is busy.
• NA–Int redirects internal calls after several rings if you don't answer.
• NA–Ext redirects external calls after several rings if you don't answer.
Note: For information about "I'm Here?", see Call Forward – Remote.
To program Call Forward:
1. Press
( SUPERKEY ).
2. Press # or the No softkey until "Call Forwarding?" appears.
3. Press * or the Yes softkey .
4. Press # or the Next softkey until the type of Call Forward that you want to set up appears
(see above).
5. On a 5224 IP Phone only, press the Review softkey.
6. If a number is already programmed, press * or the Change softkey .