Nokia 3610 - Manual (Page 14)

13
1. Connect the charger to a wall socket.
2. Connect the charger to your phone.
3. When the battery is fully charged, disconnect the
charger from the phone, then from the wall outlet.
■ Switch the phone on and off
1. Press and hold the power key.
2. If the phone asks for a PIN code, enter the code (for example,
displayed as ****), and select OK.
When you switch on your phone for the first time, and the phone is in
the standby mode, you are asked to get the configuration settings from
your service provider. Confirm or decline the query. See “Configuration‚"
p. 36, and “Configuration settings service‚" p. 10.
■ Set the time, zone, and date
When you switch on your phone for the first time, and the phone is in the standby mode, you
are asked to set the time and date. Fill in the fields, and select Save.
To change the time and date settings, select Menu > Settings > Date and time > Date &
time settings, Date and time format, or Auto-update of time (network service).
■ Antenna
Your device may have internal and external antennas. As with
any radio transmitting device, avoid touching the antenna area
unnecessarily while the antenna is transmitting or receiving.
Contact with such an antenna affects the communication
quality and may cause the device to operate at a higher power
level than otherwise needed and may reduce the battery life.