NEC NLT-32HD1 - Manual (Page 37)

37
EN
RGB-PC Menu
You can adjust horizontal/vertical position, clock, phase,
and auto-configure, reset as you prefer.
Press the MENU button and then D / E button to select
the SETUP menu.
Press the G button and then D / E button to select the
desired picture item.
Press the F / G button to make appropriate adjustments.
H-Position / V-Position
This function is to adjust picture to left/right and up/down
as you prefer.
Clock
This function is to minimize any vertical bars or stripes
visible on the screen background. And the horizontal
screen size will also change.
Phase
This function allows you to remove any horizontal noise
and clear or sharpen the image of characters.
Auto-configure
This function is for the automatic adjustment of the screen
position, clock and phase.
The displayed image will disappear for a few seconds
while the Auto-configuration is in progress.
Reset
This function allows you to return to the good picture
reproduction programmed at the factory and cannot be
changed.
Note : Some signal from some graphics boards may not
function properly. If the results are unsatisfactory, adjust
your monitor’s position, clock and phase manually.
Press the OK button to store it for the PC monitor picture.
Press the EXIT button to return to PC mode.
- When the set is inputted DVI-480p signal in VGA mode, select 480p on the SETUP menu.
- When the set is inputted WXGA signal, select the desired WXGA resolution.
WXGA or VGA (Only RGB/HDMI mode)
PC Setup
SETUP
()}{ OO OK OO MENU
H-Pos. 0
V-Pos. 0
Clock 10
Phase 15
Auto
Reset
Language
PC Control
WXGA
VGA
Input
ARC
Audio Mode
PC Control
SETUP
()}{ OO OK OO MENU
1024X768
1280X768
1360X768
1366X768
Language
PC Control
WXGA
VGA
Input
ARC
Audio Mode
WXGA
SETUP
()}{ OO OK OO MENU
640X480
480P
Language
PC Control
WXGA
VGA
Input
ARC
Audio Mode
VGA