NetComm NB1300PLUS4 - Manual (Page 74)

www.netcomm.com.au Rev. 1- YML674
Page 74 NB1300Plus4 ADSL Modem
Appendix A - Connection Instructions
Connect your NB1300Plus4 ADSL Modem via Ethernet
1. Connect your NB1300Plus4 to either a computer directly or a network hub or switch using
cat5 ethernet cables. You need to ensure you are using the correct type of ethernet cable - i.e.
straight through or crossover.
2. Connect the power pack to the NB1300Plus4 ADSL Modem and switch on the power
switch.
3. Ensure that the connected port has a LAN led light on the NB1300Plus4.
4. Ensure that the computer you intend to use has an IP address in the same subnet as the
NB1300Plus4 ADSL Modem. (e.g. the NB1300Plus4’s default IP is 192.168.1.1 - your
computer should be on 192.168.1.100 or similar.) If you have DHCP enabled on your
computer, the NB1300Plus4 will assign your computer a suitable IP address.
5. Ensure that your computer has a LAN link light.
6. Connect one end of the ADSL phone line to the NB1300Plus4 ADSL Modem and the other
end to the wall socket.
7. Additional network devices or computers can be connected to the remaining LAN ports.