beautypg.com

Nuvo NV-E6DMS User Manual

Page 29

background image

COMMAND:

*ZxxVOLyy – Set volume of zone xx to level yy below max in dB from –0 to –78 dB
(include lead 0 for all single-digit values).

RESPONSE:

Same response as for *ZxxCONSR

*********************************************************************************
COMMAND:

*ZxxVOL+ – STARTS zone xx volume ramp UP at the rate of +10 dB per second in +1 dB steps.

(This is the same as holding VOLUME UP key on a KEYPAD for 1 second).

RESPONSE:

Same response as for *ZxxCONSR, updated 10 times per second.

*********************************************************************************
COMMAND:

*ZxxVOL- – STARTS zone xx volume ramp DOWN at the rate of -10 dB per second in -1 dB steps.
(This is the same as holding VOLUME UP key on a KEYPAD for 1 second).

RESPONSE:

Same response as for *ZxxCONSR, updated 10 times per second.

*********************************************************************************
COMMAND:

*ZxxVHLD – STOPS zone xx volume ramp initiated by *ZxxVOL+ or *ZxxVOL- commands.

This results in a HOLD of the level at time of command receipt. RESPONSE: #ZxxVHLD

*********************************************************************************
COMMAND:

*ZxxMTON – zone xx MUTE ON (mutes currently connected source)

RESPONSE:

Same response as for *ZxxCONSR

*********************************************************************************
COMMAND:

*ZxxMTOFF – zone xx MUTE OFF (returns zone output to currently connected source at previous volume setting).

RESPONSE:

Same response as for *ZxxCONSR

*********************************************************************************
COMMAND:

*ZxxBASSyyy – zone xx BASS EQ with yyy = EQ level, dB, –12 to +0 (flat) to +12 in 2 dB increments.
USE LEAD "0" IN TENS PLACE FOR VALUE LESS THAN 10.

RESPONSE:

Same response as for *ZxxSETSR

NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.

*********************************************************************************
COMMAND:

*ZxxTREByyy – zone xx TREBLE EQ with yyy = EQ level, dB, –12 to +0 (flat) to +12 in 2 dB increments.

USE LEAD "0" IN TENS PLACE FOR VALUE LESS THAN 10.

RESPONSE:

Same response as for *ZxxSETSR

NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.

*********************************************************************************
COMMAND:

*ZxxGRPON – zone xx SOURCE GROUP ON.

RESPONSE:

Same response as for *ZxxSETSR

NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.

*********************************************************************************
COMMAND:

*ZxxGRPON – zone xx SOURCE GROUP ON.

RESPONSE:

Same response as for *ZxxSETSR

NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.

*********************************************************************************
COMMAND:

*ZxxGRPOFF – zone xx SOURCE GROUP OFF.

RESPONSE:

Same response as for *ZxxSETSR

NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.

29

This manual is related to the following products: