Philips DVDR 75 User Manual

Page 25

Please note the color order

The colors of the jacks on the DVD Recorder must match those on the
TV (red-red/blue-blue/green-green). If they are not matched properly,
this could cause the color of the picture to be reversed or there could
be no picture at all.

Tip

Use the supplied audio cable and plug one end into the OUT
AUDIO LR jack at the back of the DVD Recorder (next to

OUT COMPONENT VIDEO ) and the other into the red/white

Audio In jacks of the TV (usually called Audio in', 'AV in'. Please
see your TV's instruction manual).

Switch on the TV.
If necessary, set the TV to the Component Video channel.
If necessary, see the operating instructions for your TV. Or, go
to channel zero on your TV, then keep changing channels down
until you see the DVD Recorder screens (when the Recorder is
on). This is not channel 3 or 4 as it would be if you used only
the cable/antenna connection.

Connect the mains jack

4MAINS at the back of the DVD

Recorder with the power supply using the supplied power cable.
The most important features of the DVD Recorder will appear
on the display.
After the initial installation is completed, this function will be
switched off. How you switch on this function again, read in the
chapter 'User preferences' in the section 'Standby'.

Press

STANDBY/ON

m on the recorder. 'IS TV ON?' will

appear on the display.

Switching TV and DVD Recorder to 'Progressive scan'

The factory settings of the DVD Recorder are set to 'Interlaced'. If you
selected the 'Progressive scan' connection during installation, you must
switch the 'Component Video output' of the DVD Recorder and, if
necessary, the 'Component Video input' of the TV to 'Progressive scan.'

Switching the TV
Please select 'Progressive scan' for the Component Video input on the
TV. If necessary, see your TV instruction manual.
If your TV is equipped with separate input jacks for Interlaced and
Progressive, connect the DVD Recorder to the jack that supports
'Progressive scan.'

Switching the DVD Recorder

Disconnect the recorder's power cord.

Hold down

O on the DVD Recorder while reconnecting the

power cord. 'PRO' (progressive scan) will appear on the display.

If you want to switch back, repeat steps 1 and 2 . 'PRO'
(progressive scan) will disappear from the display. The DVD
Recorder is switched to 'Interlaced.'

Tip

Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD recorder'.

ENGLISH

Connecting the DVD Recorder