Pioneer PureVision PDP 5040HD - Manual (Page 54)

09 Basic Adjustment Settings
54
En
Power Control
Power Control provides convenient functions for power
saving.
Power Control for AV source
Energy Save
Power consumption is saved by decreasing picture
brightness.
1 Press HOME MENU.
2 Press / to select “Power Control”, and then
press ENTER.
3 Press / to select “Energy Save”, and then press
ENTER.
4 Press / to select “Save”, and then press
ENTER.
Item Description
Standard Does not decrease picture brightness.
(factory default)
Save Decreases picture brightness to save
power.
5 Press HOME MENU to exit the menu.
• You can also select this function using the Home
menu when the input source is a PC.
No Signal off
The system will be automatically placed into the
standby mode if no signal is received for 15 minutes.
1 Press HOME MENU.
2 Press / to select “Power Control”, and then
press ENTER.
3 Press / to select “No Signal off”, and then
press ENTER.
4 Press / to select “Enable”, and then press
ENTER.
Item Description
Disable Does not place the system into the
(factory default) standby mode.
Enable Places the system into the standby mode if
no signal is received for 15 minutes.
5 Press HOME MENU to exit the menu.
• Five minutes before the system is placed into the
standby mode, a message appears every minute.
• The system may not be placed into the standby mode
when noise signals are present at the Media Receiver
after a TV program finishes.
PDP5040HD-Eng (40-55) 7/24/03, 1:59 PM 54