Pentax Optio S10 - Manual (Page 77)

75
Tak
ing Pi
cture
s
4
(Digital SR) mode allows you to set the sensitivity higher than other
modes to reduce camera shake and blurring. Shutter speed and
aperture are set automatically according to the sensitivity value you set.
Use the mode under the shooting conditions that camera shake or
blurring tend to occur.
1
Press the four-way controller (3) in Capture mode.
The Mode Palette appears.
2
Use the four-way controller
(2345) to select
(Digital SR
mode).
3
Press the OK button.
4
Press the shutter release button
halfway.
The focus frame on the LCD monitor will light green when the camera
is in focus.
5
Press the shutter release button fully.
The picture is taken.
Reducing Camera Shake and Blurring in Pictures
(Digital SR Mode)
• The recorded pixels are fixed to 5M and cannot be changed.
• In Digital SR mode, the sensitivity can now be set to 3200. When
using the auto settings, sensitivity is automatically set within a
range of 64 to 1600. (1p.102)
Shutter release button
Four-way controller
OK button
Digital SR
OK OK MENU Cancel