beautypg.com

Replacing the fabric switch module (fsm 4000), Replacing the fabric switch module (fsm 4000) -18 – Polycom DOC2559C User Manual

Page 62

background image

Chapter 2- Component Replacement

2-18

9

Ensure that the metal ejector levers are fully retracted into their

housings.

10 Tighten the captive screws on the rear panel of the RMX 4000 that

secure the RTM LAN card.

11 Reconnect the cables.
12 Turn ON the RMX 4000.

Replacing the Fabric Switch Module (FSM 4000)

1

Ensure that the power switch/circuit switch on the RMX 4000 is

turned OFF (O).

2

Loosen the captive screws that fasten the module to the MCU.

3

Remove the Fabric Switch Module (FSM 4000). Use the metal ejector

levers to pull the Fabric Switch Module (FSM 4000) out of its slot in

the backplane.

4

Carefully slide the Fabric Switch Module (FSM 4000) out through the

front panel.

5

On the card to be installed, move the ejector levers to their fully open

position.

6

Slide in the replacement Fabric Switch Module (FSM 4000).

7

Push the Fabric Switch Module (FSM 4000) firmly into the backplane,

making sure it is properly seated in its slots.