Polycom DOC2559C - Manual (Page 47)

Polycom RMX 4000 Hardware Guide
2-3
Using the Modified PMC Compatible Ejector Lever
On the RMX 4000 most components are fitted with identical ejector levers
that are used to release or fasten the component’s to their slot.
This ejector lever can be moved to 3 positions:
•
Closed/Locked - Ejector lever(s) are gently pushed up against the
card’s panel and is locked. Ensure that the lock catch is in the
standard closed position (shifted to the right as shown below).
• Partially Open - For card powering down mode. Partially open the
ejector lever(s) until the blue HS LEDs on the card and the Control
Unit start flashing. When the HS LED is constantly lit the card is in a
powered down mode and you can remove the card.
Warning!
Once the removal sequence is initiated the process cannot be terminated and
the HS led flashes when activated.
• Fully Open - In this position the card is released from the MCU
housing and can be removed.
Handle
Unlocking the Lock Catch - With your index
finger holding the “handle” and your thumb shifting
the catch to left, gently pull the handle away from
the chassis until the lever is “fully open”
Closing the Lever - Make sure that the lever is in
an open position and push card close to the
chassis till the lever engages. With your index
finger holding the “handle” and your thumb holding
the catch fully to left, push the card against the
chassis whilst closing the lever. Use your thumb to
insert the card into place by pushing your thumb to
the right and closing the catch into a locked
position. Make sure that the lever is locked.
Lever Fully Open - Pull the lever handle(s) to a fully
open position (approx. 70 degrees), as shown here