Planet Technology VIP-150T - Manual (Page 10)

PLANET VIP-150T User’s Manual 7
Chapter 2 Configuring the VIP-150T through
LCD Phone menus
?
Note:
1. After any configuration is made for the VIP-150T, user has to do Reboot in
the selection 7 “Reboot”.
2. We suggest user to set IP address via LCD menu 5→2.3.4.5 first, then
go to chapter 3 to do other detail configurations via web browser.
2.1 Initialize VIP-150T
1. When power on the VIP-150T, the LCD screen shows as below. Now VIP-150T is
running Boot sector program.
2. When VIP-150T finishes boot program initialization. User can see flashing greeting
as below:
3. Then VIP-150T get into standby mode:
The main LCD screen would be shown as similar as above.
“
Proxy
” means the
VIP-150T is in Proxy Mode, and when VIP-150T is connected to SNTP server, on
LCD will show current time captured from SNTP server.
4. When VIP-150T is under peer-to-peer mode, on LCD will show
“
P2P
” instead of
“
Proxy
”.
5. After pressing the PSTN button, the “ Proxy ” or “ P2P ” will be replaced by “PSTN”.
Please notice that user must plug PSTN line in RJ-11 port when VIP-150T is in PSTN
VIP-150T
Board Start Booting
System Initializing …………..
VIP-150T
Proxy 10:10:10 AM
VIP-150T
P2P 10:10:10 AM