Paxar TC6021OH - Manual (Page 20)

Removing Supplies
1. Open the dust cover until it locks (Figure 6).
2. Tear evenly across the supply strip and remove the roll of
supplies.
3. Push the power switch on.
If you don’t see FORMAT? prompt, press
5
until
you see the prompt.
4. Press
= 4
. The display shows:
RELOADING
5. Press the trigger to feed the backing paper out through the
rear of the printer.
6. Press
0
to exit. You’ll see
SUPPLY? TYPE B
Enter 1 for TYPE? A or enter 2 for TYPE? B
1
. Press
-
.
You’ll see the FORMAT? prompt.
1
The supply type you enter can be found on the supply carton.
Backing
Paper
Power
Switch
Figure 6
Operator’s Handbook
12