Philips AC4083 - Manual (Page 26)

Replacing the filters and resetting the appliance
Tip: Place the appliance against a wall for more stability when you remove or
insert filters.
1 Switch off the appliance and unplug it.
2 Follow the instructions in chapter ‘Before first use’, section ‘Placing
the filters’ to remove old filters and place new filters.
Note: Always use a new filter to replace an old filter.
Note: Make sure you reattach the front panel properly.
3 Put the plug in the wall socket.
4 Press the on/off button to switch on the appliance.
, The speed light under the filter number concerned and the
REPLACE FILTER lights still flash or still light up continuously when
you switch on the appliance.
, If the appliance was locked before you replaced the filter or filters,
the appliance is still locked.
5 Reset the appliance to switch off the filter replacement indication or
to unlock the appliance
- Press and hold the SPEED button for 3 seconds
- You hear a ding-ding sound to indicate that the appliance has been
reset.
Note: Make sure the appliance is switched on when you reset it.
Accessories
New filters are available under the following type numbers:
Filter Type number
Filter 2: multi-care filter AC4141
Filter 3: activated carbon filter AC4143
Filter 4: HEPA filter AC4144
Filter 5: humidification filter AC4145
Filter 6: water softener AC4146
Environment
- Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this, you help to preserve the environment.
2
1
3 sec.
English
26