Panasonic AW-E600 - Manual (Page 42)

-40-
#1 Electronic Shutter Mode Setting [Shutter Mode:
Step/ ELC/ S/Scan]
Step:
Electronic shutter operates at the speed
selected by the Electronic Shutter Step Setting
#2.
ELC: Electronic shutter is controlled to automatical-
ly adjust the luminance.
S/Scan (Synchro Scan): Electronic shutter oper-
ates at the speed selected in Electronic Shutter
Synchro-Scan Setting
#3.
#3 Electronic Shutter Synchro-Scan Setting
[Synchro Scan: 60.34 Hz - 15.75 kHz]
This setting is possible only when Electronic Shutter
Mode Setting
#1 is at S/Scan.
Bar noise can be reduced by synchro-scan adjust-
ment in shooting workstation scenes, for example.
* For luminance setting at each shutter speed and
synchro-scan shutter speed, refer to the table on the
next page.
If Frame 1 is selected in CCD Read Out Mode
Setting
#4, Electronic Shutter Mode Setting cannot
be added.
Note
#2 Electronic Shutter Step Setting
[Step: OFF/1/100 - 1/10 000]
This setting is possible only when Step is selected
in Electronic Shutter Mode Setting
#1.
OFF: Electronic shutter is turned off.
1/100, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000,
1/10 000:
Electronic shutter operates at one of these
speeds as selected.
• In case of using the RCU (RCB), none of the shut-
ter speeds–1/250, 1/2 000, 1/4 000, and 1/10 000
can be selected.
• In case of using the hybrid control panel, only
OFF, 1/100, or ELC can be selected.
• If the lens iris switch is at M (Manual) when oper-
ating the camera alone or when the iris switch on
the RCU (RCB) is at AUTO, ELC may not function.
Set the lens iris switch to A (Auto).
• Flickering may increase at ELC under fluorescent
lights.
Notes