Pioneer S-EV500V - Manual (Page 8)

Connecting up 02
8
En
Chapter 2
Connecting up
Important
• Before making or changing any
connections, switch off the power and
unplug the power cord from the AC outlet.
• When making cable connections, make
sure not to bend the cables over the top of
this unit. This may cause a humming noise
from the speakers.
Connecting the speaker
terminals
Connect the wires from the speakers to the
terminals on the main unit rear panel as shown
below. Before connecting, you may want to
consider the placement options available in
your room, and when using this system:
1
• EV500 model only – Place the front left and
right speakers at equal distances from the
TV, then connect them as shown below.
See
Optional surround speaker connections
on page 10 to connect surround speakers.
• EV700/1000 model only – A color-coded
system is provided for speaker connections
(see
Multichannel speaker connections
below). See Home theater sound setup on
page 23 for surround placement options.
Caution
• Do not connect this speaker to any amplifier
other than the one supplied with this
system. Connection to any other amplifier
may result in a malfunction or fire.
• Make sure that the bare speaker wires
cannot touch each other, or come into
contact with other metal parts once the
unit is switched on.
1 Twist and pull off the protective shields
on each wire.
2 Connect to the speaker terminals on the
rear of the unit.
Make sure to insert the red/colored wire into
the red/colored (+) tab and the black/white
wire into the black (–) tab.
3 EV 1000 only: Connect to the terminals on
the rear of the subwoofer and front speakers
in the same way.
Note
1 • The speakers supplied with this system are magnetically shielded. However, placing them extremely close to a television
may result in color distortion on the screen. If this happens, move the speakers a little further away and switch off the television
for 15–30 minutes.
EV-500-1000.book 8 ページ ２００５年４月５日 火曜日 午後１２時３１分