Polycom RMX DOC2548A - Manual (Page 46)

Chapter 2- Component Replacement
2-4
Replacing the CNTL 4000 Module
The CPU module is the management system of the RMX 4000. Use the
following procedure to replace a CNTL 4000 Module:
1
Ensure that the power switch/circuit switch on the RMX 4000 is
turned OFF (O).
2 Unscrew the captive screws on the front panel of the CNTL 4000
Module that secure the m odule to the chassis.
3 Use the metal ejector lever to pull the CNTL 4000 Module out of its
slot in the Backplane.
4 Carefully slide the CNTL 4000 Module out through the front panel.
5 On the CNTL 4000 Module to be installed, move the ejector lever to
the fully open position.
6 Slide in the replacement CNTL 4000 Module.
7 Push the CNTL 4000 Module firmly into the Backplane, making sure
it is properly seated in its slot.
8 Ensure that the metal ejector lever is fully retracted into it’s housing.
9 Tighten the captive screws on the front panel of the CNTL 4000
Module that secure the CNTL 4000 Module to the chassis.
10 Turn ON the RMX 4000.
Captive screws