Polycom RMX DOC2548A - Manual (Page 12)

Chapter 1- Hardware Description
1-6
Safety Requirements
This section describes the requirements your site must meet for safe
installation and operation of the system.
Site Safety Requirements
For your protection, please read these safety instructions completely
before operating the equipment.
•
Look carefully for potential hazards in your work area: moist floors,
ungrounded power cables, frayed power cords, missing safety
grounds and so forth.
• Locate the main circuit breaker within the room.
• Locate the emergency power OFF switch within the room.
• Never assume that power is disconnected from a circuit.
• Use only the power cords supplied with the system.
• Each power cord should only be connected to a power outlet that has
a protective ground contact.
• Ensure that power cords are easily accessible from the back of the
system at all times.
• Place the equipment in a well-ventilated area where the vents are free
from obstruction.
• Do not place heavy objects directly on top of the RMX 4000 unit.
• Do not use liquids around your equipment.
• Keep the area around the RMX 4000 clean and free of clutter.
• Decide on a suitable location for the equipment rack that will hold the
RMX 4000 unit. It should be situated in a clean, dust-free area that is
well ventilated. Avoid areas where heat, electrical noise and
electromagnetic fields are generated. You will also need it placed
near a grounded power outlet.