Premier Mounts PP-FCTA-QL - Manual (Page 5)

Installation Instructions Page 5
PP-FCTA-QL
Securing the Plate
Adjust and Tighten
Wing Nut
M5 x 16mm Set
Screw
Tiles
T-Bar Frame Rails
Step 1. Position and slide the adapter plate to the hole and secure the ceiling plate to the rails by tightening the four (4) M5 x 16mm
Phillips head screws.
Step 2. Center the stud plate to the hole and secure the plate by tightening the four wing nuts..
Electrical installation should be done in accordance to local codes and regulations.
Step 1. Cut the tile where the electrical base box is going to be secured.
Step 2. Using (commercially available) hardware depending on electrical installation environment, install the electrical box and secure
it to the plate.
Step 3. Make all electrical connections at this time.
Electrical Box Installation
Electrical Box
Cut-out
CUT