beautypg.com

4 get started, Plug & play, Prepare the remote control – Philips DCM109 User Manual

Page 14

background image

14

Note

If you are not going to use the remote control

for a long time, remove the batteries.
Do not use old and new or different types of

batteries in combination.
Batteries contain chemical substances, so they

should be disposed of properly.
Perchlorate Material - special handling may

apply. See www.dtsc.ca.gov/hazardouswaste/
perchlorate.

Plug & Play

When you connect the unit to the power
supply for the first time, or no radio station
is stored in this unit, Plug and Play mode is
activated to store all available radio stations
automatically.

1

Connect the unit to the power supply.

[AUTO INSTALL - PRESS PLAY, STOP

»

CANCEL] (auto install - press the PLAY
button; to cancel, press ) displays.

2

Press on the main unit to start

installation.

[AUTO] (auto) displays.

»

[PROG] (program) flashes.

»

The unit automatically store radio

»

stations with sufficient signal strength.

3

When all the available radio stations are

stored, the first preset radio station is
broadcast automatically.

Tip

If no key is pressed during Plug and Play

mode, the system goes to Standby mode
after timeout of 5 times. To go to installation
again, press and hold

for 3 seconds under

Standby mode.


Toexit Plug and Play installation mode

1

press source keys or on the remote

control.

4 Get

started

Caution

Use of controls or adjustments or

performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.

Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
rear of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

Caution

Risk of explosion! Keep batteries away from

heat, sunshine or fire. Never discard batteries
in fire.

1

Open the battery compartment.

2

Insert 2 AAA batteries (not supplied)

with correct polarity (+/-) as indicated.

3

Close the battery compartment.

3

1

2

EN

This manual is related to the following products: