Printronix T3306 User Manual
Page 39
2–19
Setting Up the Printer
NOTE: The printer must be properly configured for the appropriate
interface. The RS–422 port is enabled or disabled via a DIP switch
inside the printer. Make sure this selection is properly made for your
application. If your application requires a change in switch setting,
contact your authorized Printronix service person.
2.
Verify that the site line voltage is the same as the voltage specified in
the “Power Requirements” section, on
3.
Make sure the printer power switch is set to O (OFF).
4.
Connect the power cord (supplied with the printer) to the AC power
connector on the printer.
NOTE: To avoid possible electrical interference, separate the AC power
cord from the interface cable.
5.
Connect the opposite end of the power cord to the AC line receptacle.
6.
Turn the printer power switch to | (ON).