Paradyne 24-Port SHDSL Mini DSLAM SMD2000-24T - Manual (Page 9)

9
Powering Up the SMD2000-24T
C
AUTION
:
Turn your DC power source off until you have completed connection of the
SMD2000-24T as described below.
Do not operate your SMD2000-24T without a ground connection.
Procedure
To connect the SMD2000-24T to power:
1. Connect a ground wire to the SMD2000-24T. Line up the 2-hole terminal lug of
your ground wire with the two holes on the small, unpainted section on the left side
of the back of the chassis. Secure the terminal lug to the chassis with two #10-32
screws.
2. Connect the other end of the ground wire to a frame ground. This can vary
from location to location, but typically all equipment in a Central Office is grounded
to a common copper bus.
3. Select a terminal block. Either terminal block on the back of the SMD2000-24T
may be used to power the chassis. Both terminals may be connected if redundancy
(backup) is desired.