Paradyne 24-Port SHDSL Mini DSLAM SMD2000-24T - Manual (Page 5)

5
Installing Uplink Interface Modules (Optional)
An SMD2000-24T does not require installation of an Uplink Interface Module (UIM) for
operational purposes. A UIM offers additional upstream network ports to supplement the
two T1 uplink ports already provided. You may wish to install a UIM if your network
requires an Ethernet uplink connection or if you require an additional E1 or T1 backhaul.
The SMD2000-24T supports the following 1-port UIMs only:
„
UIM-E1
„
UIM-T1
„
UIM-10/100
C AUTION :
Disconnect all power sources from the SMD2000 before installing a UIM.
Procedure
To install a UIM:
1. Remove the Chassis Cover. Using a Phillips Screwdriver, remove the eight
flathead screws securing the SMD2000-24T chassis cover and set them aside.
Carefully lift off the chassis cover and set it aside.
Side
Side
Top
Rear
Bottom