Panasonic DVCPRO50 AJ-D960EG - Manual (Page 94)

94 (E)
Video output signals and servo reference signal
This section explains how the output signals and servo reference signal are selected.
External synchronization of video output signals
The video output signals are output in synchronization with the REF VIDEO input signal or
video input signal.
As shown in the figure below, this signal is selected in accordance with the setup menu
settings, VTR mode and availability of the video input signal.
YES
NO
YES
NO
Is the unit in one of
the editing modes?
INPUT EXT
AUTO
Start
N-VF
VF NO
NO YES
YES
NO
YES
STD
AUTO
STD
NO
NON-STD
NON-STD
YES
NO
What is the setup
menu No. 304 (SERVO
REF) setting?
Is the REF VIDEO
input signal available?
Has the unit been set to
the recording mode?
Is the REF VIDEO
input signal available?
What is the setup
menu No. 601 (OUT VSYNC)
setting?
Is the video input
signal available?
Is the video input
signal available?
Is the video input signal
a composite signal?
What is the setup
menu No. 303 (STD/NON-
STD) setting?
Is the video input
signal a standard or non-
standard signal?
Internal synchronization
Synchronization with
the video input signal Synchronization with the
REF VIDEO input signal
YES
Synchronization is determined as follows depending on the availability of the REF VIDEO input
signal when “BB” or “CB” has been selected as the setup menu No. 600 (INT SG) setting.
• When the REF VIDEO input signal is available: Synchronization with the REF VIDEO input
signal
• When the REF VIDEO input signal is not available: Internal synchronization