Panasonic DMR-EH60 EN User Manual
Page 19
19
RQT8307
Ge
ttin
g
st
a
rte
d
You can configure the remote control TV operation buttons to turn
the television on/off, change the television input mode, select the
television channel and change the television volume.
1
Point the remote control at the television
While pressing [
Í POWER TV] enter
the code with the numbered buttons.
e.g., 01: [0]
➡ [1]
10: [1]
➡ [0]
Manufacturer and Code No.
2
Test by turning on the television and
changing channels.
≥Repeat the procedure until you find the code that allows
correct operation.
≥If your television brand is not listed or if the code listed for
your television does not allow control of your television, this
remote control is not compatible with your television.
[Note]
≥If your television brand has more than one code listed, select the
one that allows correct operation.
Change the remote control code on the main unit and the remote
control (the two must match) if you place other Panasonic products
close together.
Use “1”, the factory set code, under normal circumstances.
1
Press [SETUP].
2
Press [
3, 4] to select “Setup” and
press [
1].
3
Press [
3, 4] to select “Remote
Control Code” and press [ENTER].
4
Press [
3, 4] to select the code (1, 2,
or 3) and press [ENTER].
5
To change the code on the remote control
While pressing [ENTER], press and
hold the numbered button ([1], [2] or
[3]) for more than 2 seconds.
6
Press [ENTER].
∫ When the following indicator appears on the
unit’s display and you are unable to operate the
unit
Change the code on the remote control to match the main unit’s
(
➡ step 5).
To return to the previous screen
Press [RETURN].
To exit the screen
Press [SETUP].
∫ Off Timer
The unit switches to standby after about 6 hours in the stop mode.
You can turn this feature off or change the time to 2 hours (
➡ 54,
“Off Timer”).
Television operation
Panasonic
National
QUASAR
01/02
PHILIPS (RC-5)
03
RCA
05
SAMSUNG
14/18/19
FISHER
10
SANYO
10
GE
05
SHARP
06/07
GOLDSTAR
15/16/17
SONY
08
HITACHI
12
SYLVANIA
03
JVC
11
THOMSON
05
LG
15/16/17
TOSHIBA
09
MAGNAVOX
03
ZENITH
04
MITSUBISHI
13
When other Panasonic products
respond to this remote control
Power saving function
SETUP
Remote Control Code
Pres
s “
±” and “ENTER” together
for more than 2 seconds on the remote.
Disc
Channel
Setup
The unit’s remote control code
EH60English.book Page 19 Monday, July 4, 2005 10:39 AM