Pioneer Super Tuner III D DVH-P5850MP - Manual (Page 82)

Black plate (82,1)
82
Switching the automatic
disc playback
You can turn automatic disc playback on or off
when you insert a disc into the disc loading
slot. When this function is on, the disc will be
automatically played after it is inserted into
the disc loading slot.
Initially, this function is set to on.
1 Press F to select DSC-A.
Press F repeatedly until DSC-A appears in the
display.
2 Press r to turn automatic playback
on.
DSC-A:ON appears in the display.
# Press q to turn automatic playback off.
Correcting distorted sound
Only when the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you can
operate this function.
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to LOW. Normally, leave the set-
ting at HI to ensure quality sound.
1 Press F to select D_ATT.
Press F repeatedly until D_ATT appears in the
display.
2 Press r or q to select LOW or HI.
Pressing r or q will switch between HI
(high) and LOW (low) and that status will be
displayed.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down F until the unit turns off.
Resetting the audio functions
Only when the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you can
operate this function.
You can reset audio functions other than the
following settings.
! Volume setting (refer to Adjusting the vo-
lume on page 16)
! Listening position setting (refer to Using
the position selector on page 63)
! Fader/balance setting (refer to Using bal-
ance adjustment on page 63)
! SLA (source level adjustment) setting (refer
to Adjusting source levels on page 63)
! Dynamic range control (refer to Using the
dynamic range control on page 64)
! Direct control setting (refer to Using the di-
rect control on page 64)
! Down-mix setting (refer to Using the down-
mix function on page 64)
1 Press F to select A-RESET.
Press F repeatedly until A-RESET appears in
the display.
2 Press r to display RESETOK?.
RESETOK? appears in the display.
# To cancel resetting the audio functions, press
BAND.
3 Press n to display REALLY?.
REALLY? appears in the display.
# To cancel resetting the audio functions, press
BAND.
4 Press r to reset audio functions.
COMPLETE appears in the display.
Initial Settings
En
82
Section
14