Philips Network Adaper - Manual (Page 7)

13 12
VIDEO VIDEO AUDIO AUDIO
RF IN RF IN
S-VIDEO S-VIDEO S-AUDIO S-AUDIO CLONE CLONE
PORT PORT
VIDEO VIDEO AUDIO AUDIO
RF IN RF IN
S-VIDEO S-VIDEO S-AUDIO S-AUDIO
CLONE CLONE
PORT
PORT
IN OUT
1
2
VIDEO VIDEO AUDIO AUDIO
RF IN RF IN
S-VIDEO S-VIDEO S-AUDIO S-AUDIO
CLONE CLONE
PORT
PORT
VIDEO VIDEO AUDIO AUDIO
RF IN RF IN
S-VIDEO S-VIDEO S-AUDIO S-AUDIO CLONE CLONE
PORT PORT
OR
OUT TO TV IN FROM ANT.
1
2
O
PTIONAL
VCR H
OOKUP
Round Cable
75 Ω Supplied
with VCR
VCR
Outdoor VHF/UHF
Antenna
300 to 75 Ω Ohm
Adapter
Cable TV signal
Back of TV
Net1Card
Jack Panel
Back of TV
Round Cable
75
Ω
Ohm
Cable TV Converter Box
Connection
Cable TV Company
Net1Card
Jack Panel
Y our Cable TV input into your home may be
a single (75 ohm) cable, or a Converter
Box installation. In either case the connection
to the TV is very easy. Just put the threaded
end of the cable signal to the TV's antenna
plug and screw it down tight.
If your Cable TV signal is a single round
cable (75 ohm) then you're ready to connect to the
TV.
If you have a Cable TV Converter Box:
Connect the Cable TV signal to the Cable Signal
IN(put) plug on the Converter.
Connect the Cable TV cable to the RF IN plug
on the TV.
If you have a Cable TV Converter Box:
Connect the OUT(put) plug from the Converter to
the RF IN plug on the TV (connecting cable sup-
plied with the Converter).
BEGIN
Remember, set the TV to the “Cable TV
Mode.” Then, to select only the channel
numbers on your Cable system see “Auto
Program” (refer to page 34 for both features).
If you use a Cable Converter box, set the TV to
the same channel as the converter's CH 3/4 switch
(on the rear of the converter.)
S MART H ELP
C
ABLE
TV H
OOKUP
Net 1Card IB 2/15/00 12:17 PM Page 12