Philips Network Adaper - Manual (Page 10)

19 18
C
OMMERCIAL
S
ETTINGS
O nce the Net1Card is installed and the TV plugged
back in, you can perform Net1Card setup opera-
tions for the TV. You should start with the “COMMER-
CIAL SETTINGS” menu.
To begin setup, press the POWER button to turn
the TV on. Then press the TV/GUEST button.
Press the A button on the remote control. The
“COMMERCIAL SETTINGS” menu appears. (The
menu stays up for approximately 2 minutes.) “MODE”
is highlighted. Press the – (
ᮤ ) or + ( ᮣ ) button to select
“COMMERCIAL,” or “CONSUMER.” Selecting
“CONSUMER” allows you access to the TV's “SETUP
MENU” with a standard remote or from the front panel
on the TV. (See page 32 for details.) “COMMERCIAL”
is the default setting. In the Commercial mode, the TV's
menu can only be accessed with a Setup remote control.
When finished, press the ▼ button to highlight
“CONTROL MODE.”
BEGIN
C
OMMERCIAL
S
ETTINGS
C ONTROL MODE allows you to setup each TV as a
“TRANSMITTER,” “RECEIVER,” or “FACTO-
RY.”Since almost all the TV's in the Net1Card network
will be receivers, the default mode is “RECEIVER.”
If not already in the “COMMERCIAL SET-
TINGS” menu, press the A button on the remote con-
trol. Then press the ▼ button to highlight “CONTROL
MODE.”
Press the – ( ᮤ ) or + ( ᮣ ) button to select “TRANS-
MITTER,” “RECEIVER,” or “FACTORY.” Select
“TRANSMITTER” if the TV will be sending informa-
tion to the other TVs in the Net1Card network. Select
“RECEIVER” if the TV will be receiving information
sent by the Transmitter TV. Select “FACTORY” if you
want to send a signal to an individual TV to test if it is
correctly hooked up to the system. (More on these
modes later.)
When finished, press the ▼ button to highlight
“FRONT KEYPAD.”
BEGIN
COMMERCIAL SETTINGS
MODE COMMERCIAL
CONTROL MODE RECEIVE
FRONT KEYPAD ON
CABLE YES
EXIT MENU
PRESS +/– TO CHANGE
COMMERCIAL SETTINGS
MODE CONSUMER
CONTROL MODE RECEIVE
FRONT KEYPAD ON
CABLE YES
EXIT MENU
PRESS +/– TO CHANGE
COMMERCIAL SETTINGS
MODE COMMERCIAL
CONTROL MODE RECEIVE
FRONT KEYPAD ON
CABLE YES
EXIT MENU
PRESS +/– TO CHANGE
COMMERCIAL SETTINGS
MODE COMMERCIAL
CONTROL MODE TRANSMIT
FRONT KEYPAD ON
CABLE YES
EXIT MENU
PRESS +/– TO CHANGE
COMMERCIAL SETTINGS
MODE COMMERCIAL
CONTROL MODE FACTORY
FRONT KEYPAD ON
CABLE YES
EXIT MENU
PRESS +/– TO CHANGE
Net 1Card IB 2/15/00 12:17 PM Page 18