Maintenance and lubrication, Warning, Engine cooling system – Polaris ATP 330 4x4 User Manual

Page 92

MAINTENANCE AND LUBRICATION

Engine Cooling System

Coolant Level (ATP 500)

The recovery bottle (1) is located on the

left side of the machine. To access the

recovery bottle, remove the left side panel.

See page 97.
Maintain the coolant level between the

minimum and maximum marks on the

bottle (when the fluid is cool).

WARNING

Escaping steam can cause severe burns. Never remove the

pressure cap while the engine is warm or hot. Always allow the

engine to cool before removing the pressure cap.

Radiator Coolant Level (ATP 500)

Checking the radiator coolant level is

required only if the cooling system

has been drained for maintenance

and/or repair. However, if the

recovery bottle has run dry, the level

in the radiator should also be

inspected. Add coolant if necessary.
1. Using the tool provided, remove

the four screws securing the front

compartment (1). Remove the

front cover (2) by placing your

fingers under the front of the cover

and pulling upward.

2. Remove the pressure cap.
3. Using a funnel, slowly add coolant as necessary through the

radiator filler neck.

4. Replace the pressure cap and secure the front cover.

NOTE: Use of a non-standard pressure cap will not allow the

recovery system to function properly. Contact your dealer for

the correct replacement part.