beautypg.com

Maintenance and lubrication, Caution, Lubrication recommendations – Polaris ATP 330 4x4 User Manual

Page 83

background image

80

MAINTENANCE AND LUBRICATION

Lubrication Recommendations

Engine Oil

Oil Check (ATP 500)
The oil tank is located on the left side

of the vehicle.
1. Position the ATV on a level

surface.

2. Start the engine and let it idle for

20-30 seconds. Stop the engine.

3. Remove the dipstick (1) and wipe

it dry with a clean cloth.

4. Screw the dipstick completely in.

NOTE: The dipstick must be screwed completely in to keep the

angle and depth of the stick consistent.

5. Remove the dipstick and

read the oil level.

Maintain the oil level in

the normal operating

range (2). Do not overfill.

Oil and Filter Change (ATP 500)

CAUTION

If the ATV is left without oil in the system for extended periods,

the oil pump may lose its prime, which could result in engine

damage. Always replace the oil and filter within a few hours of

draining the oil. Do not allow the vehicle to be without oil

overnight.

1. Obtain the correct oil filter and an adequate supply of oil so the oil

and filter change can be completed without interruption.

2. Position the vehicle on a level surface. Clean the area around the

drain plug at the bottom of the oil tank and the bottom of the

engine.

3. Run the engine for two to three minutes, then turn it off.

CAUTION

Hot oil can cause serious burns to skin. Do not allow hot oil to

come into contact with skin.

1

ADD 8 OZ.

NORMAL

FULL

2