Philips FW-P900 - Manual (Page 32)

32
English
3139 115 20411
Troubleshooting
TAPE OPERATION/RECORDING
Recording or playback cannot be made. – Clean deck parts, see “Maintenance”.
– Use only NORMAL (IEC I) or IEC type II (Cr0
2
)
tape.
– Apply a piece of adhesive tape over the missing
tab space.
The tape deck door cannot open. – Remove and reconnect the AC power plug and
switch on the system again.
Recorded material sounds strange. – Switch off Dolby Pro Logic mode when
recording.
GENERAL
The system does not react when buttons – Remove and reconnect the AC power plug and
are pressed. switch on the system again.
Sound cannot be heard or poor quality. – Adjust the volume.
– Disconnect the headphones.
– Check that the speakers are connected correctly.
– Check if the stripped speaker wire is clamped.
The left and right sound outputs are – Check the speaker connections and location.
reversed.
The remote control does not function
– Select the source (CD or TUNER for example)
properly. before pressing the function button (Й,н,л, ).
– Reduce the distance to the system.
– Insert the batteries with their polarities
(+/– signs) as indicated.
– Replace the batteries.
– Point in the direction of the system’s sensor.
The timer is not working. – Set the clock correctly.
– Press the TIMER ON/OFF to switch on the timer.
– If recording is in progress, stop recording.
The sound from the external source is – Press AUX to select CDR/DVD mode for
distorted. listening to the external source.
Not all lighted buttons are showing light. – Press DIM until the DIM OFF display mode is
shown.
The Clock/Timer setting is erased. – Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer
again.
The system displays features – Press and hold DEMO STOP Çon the system
automatically and buttons start flashing. to switch off the Demonstration.
pg 001-033/P900/37-Eng 12/8/00, 1:53 PM 32