Precor 5.23 - Manual (Page 20)

Owner’s Manual: Display Console 18
CROSSRAMP ▲ ▼ (EFX5.23):
Press and hold the CROSSRAMP arrows to increase
or decrease the ramp incline from 1 to 20.
Changes to the ramp incline are not immediate. It
takes time for the lift to reach the target incline shown
on the display.
Important: Ramp changes occur only when the foot
pedals are in motion. The number that appears on the
display indicates the selected range, not the degree of
incline. There is not a one-to-one relationship between
the degree of incline and the CrossRamp setting.
Table 3 shows the degree of incline for each
CrossRamp setting.
Table 3. Incline movement
The incline setting affects the column height in the
program profile as shown in Diagram 8.
Diagram 8: Column height affected by changes in incline
Note: During the setup phase, pressing the
CROSSRAMP arrow keys will not affect the ramp
incline. However, the arrow keys do affect what appears
on the display. Refer to Selecting a Program.
Unit Incline Setting Degree of Incline
EFX5.23 1 through 20 13° through 40°
EFX5.33 Stationary Fixed at 20°
1 – 3
4 – 6
7 – 8
9 – 10
11 – 12
13 – 14
15 – 20
Column height Incline Setting
EFX_Owners Manual.book Page 18 Friday, June 16, 2006 9:25 AM