Paradyne T1 Access Mux 916x - Manual (Page 4)

4
Sync Data Ports
Configuration Option Settings Default in [Bold]
Slot ss 9x62: 01, 02
9x65: 01, 02, 03, 04, 05
Port p T1 NAM:1, 2
Sync Data APM: 1, 2, 3, 4
Port Status Enable, [Disable]
Port Type [E530], V.35, RS449, X.21
Port Base Rate [Nx64], Nx56
Transmit Clock Source [Internal], External
Invert Transmit Clock Enable, [Disable]
Invert Transmit and Received
Data Enable, [Disable]
Send All Ones on Data Port Not
Ready Disable, DTR, RTS, [Both]
Action on Network Yellow Alarm None, [Halt]
Network Initiated Data Channel
Loopback (DCLB) [Disable], V.54, FT1, Both
Port (DTE) Initiated Loopbacks [Disable], DTPLB, DCLB, Both
Embedded Data Link Enable, [Disable]
EDL Management Link Enable, [Disable]
IP Address 1 [000.000.000.000] – 223.255.255.255, Clear
Subnet Mask [000.000.000.000] – 255.255.255.255, Clear
Routing Information Protocol None, [Proprietary]
Near-End Performance Statistics [Disable], Maintain, Send, Both
Far-End Performance Statistics [Disable], Maintain
Out of Frame (OOF) Alarm [Enable], Disable
Excessive Error Rate (EER)
Alarm [Enable], Disable
Excessive Error Rate Threshold [10E-4], 10E-5, 10E-6, 10E-7, 10E-8, 10E-9
1 This first byte cannot be set to 0 nor 127. However, the null address of 0.0.0.0 is
valid after performing a Clear.