Panasonic AJ- DCP - Manual (Page 29)

29
O
If the PAGE button and DATA+ button or DATA– button are pressed when the CHARA H-POS or
CHARA V-POS item has been set, the counter display appears temporarily while this button is held
down to enable the setting to be checked.
Even while the PAGE button is pressed, the settings can be performed using the DATA+ button or
DATA– button while the actual status is checked.
000 LOCAL ENA
0000
0001
0002 DIS
ST&EJ
ENA
For setting the switches which can be operated on the front panel when the
REMOTE/LOCAL switch has been set to REMOTE.
0: None of the switches can be operated.
1: Only the STOP and EJECT switches can be operated.
2: All operations are possible except for the COUNTER button and RESET
button.
001 TAPE TIMER
0000
0001 ±12h
24h
For setting the CTL counter to the 12-hour or 24-hour display system.
0: 12-hour display system
1: 24-hour display system
002 SUPER
0000
0001 OFF
ON
For setting whether to display the time code, etc. onto the video monitor
output by superimposing it.
0: Superimposed data is not displayed.
1: Superimposed data is displayed.
003 DISPLAY SEL
0000
0001
0002
0003 TIME
T&STA
T&R
T&S&R
For setting what is to be displayed by superimposing onto the video monitor
output.
0: Only the time is displayed.
1: The time and operation status are displayed.
2: The time and amount of remaining tape are displayed.
3: The time, operation status and amount of remaining tape are displayed.
004 CHARA H-POS 0000
0004
0008
0
4
8
For setting the character position in the horizontal direction for the
superimposed display.
005 CHARA V-POS 0000
0022
0
22
006 CHARA TYPE
0000
0001 WHITE
W/OUT
For setting the type of superimposed display and menu display.
0: White characters are displayed on a black background.
1: White characters with black borders are displayed.
007 SYS FORMAT
0000
0001 50M
25M
For setting the unit’s recording and playback format.
0: 50 Mbps mode
1: 25 Mbps mode
008 PB FORMAT
0000
0001
MANUAL
AUTO
For setting the format during tape playback.
0: Setting is based on the setting selected for menu item No.007 (SYS
FORMAT).
1: Setting is based on the format recorded on the tape.
BASIC menu
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
The underlining indicates the factory setting.
Setup Menus
For setting the character position in the vertical direction for the
superimposed display.
A setting from 0 to 18 is valid in the T&S&R mode (3-line display).
A setting from 0 to 20 is valid in the T&STA mode or T&R mode (2-line
display).